User's Manual

9-6 ILS 2.6 User Guide
To place Circulation Circuits on DiscMate DVD cases
This procedure only applies to DVD cases. To place standard 2" x 2" Circulation Circuits
on DiscMate DVD (single or double) cases:
1 If necessary, unlock the case.
2 Open the DVD case.
3 Peel the backing from the Circulation Circuit.
Figure 9.8 Sample Placement of Label on a CD/DVD Case
4
On the inside the front of the case, place the Circulation Circuit into the very top right
corner, as close to the spine and top of the case as possible. Make sure that the dot is
farther away from the spine and top of the case, as seen above.
5 If desired, affix a library cover-label sticker over the Circulation Circuit.
Note When re-inserting DVD covers, do not use original artwork that is made of cardboard weight stock.
The thicker cover may not allow the DiscMate case to slide through the DiscMate opening properly,
due to the material’s thickness. Original artwork should be scanned or copied onto regular (20 lb.)
paper stock before putting under the dust jacket.
Dot