User's Manual

363325 Rev. 01 Page 11 of 9
Maintenance
Care of the Omni verifier
•
Clean the verifier with a soft damp cloth.
•
Return the verifier to the docking station if the green light flashes while the verifier is in use.
•
Leave the verifier in the docking station when not in use.
Do Not
•
Replace rechargeable battery.
•
Drop the Omni Verifier.
•
Clean with solvents.
•
Clean with abrasive materials.
•
Leave on or near a room heater.
•
Immerse in water
•
Leave in direct sunlight.
•
Use the Omni Verifier for any purpose other than that for which it was intended.
•
Attempt to open the unit. There are no user serviceable parts inside.
•
Dispose or incinerate this unit without checking with your local regulations regarding rechargeable batteries.
Warranty
The warranty does not extend to any equipment that is damaged or defaced due to abnormal handling or misuse, nor to any
equipment altered or modified in design, construction or repaired by anyone other then persons authorized by Checkpoint.
Specifications and Compliance
Operation Duration Up to 8 hours of continuous operation in Portable Tag Verifier mode.
Detection Range PV mode: 3” - 5” (7 - 12 cm) Depending on label size and environment. See Figure 4 for
approximate detection area.
Operating/Storage Temperature 32° F – 100° F (0° C - 40° C)
Battery 7.2V 1600mAH Ni-MH
Docking Station Supply 100 – 240VAC 50/60 Hz
Charging Time 4 hours
Weight 1.2 Lbs. (0.55 kg) A wrist strap is supplied with the unit for prolonged use.