User's Manual

Using Source Tagging Tester: Initial Configuration of STT Software 2-5
The yield is the amount of good tags you wish to achieve for each line and each roll.
For example, in Unit 1 above, the program is set for 95% yield, which only allows for
5% of tags to fail.
6 Type the yield you wish to maintain for each unit you are programming. If not using all
units (as programmed in step 3), leave the default value in the field.
7 In the Overall field, type the final successful yield for all of the units.
8 Once complete, click Save and Exit to save the information. Otherwise, click Exit to
exit without saving your changes.
9 Next, click File > Yield COM Setup to access COM Port Setup.
Figure 2.3 COM Port Setup
Note: Multiple COM Ports refers to the usage of an RS232/COM port expansion unit.
10 Select only the COM ports you will use for tag testing. Otherwise, leave the
checkboxes blank. The COM ports must be selected sequentially and COM1 must
always be selected, as that is the computer itself. COM2-COM8 refers to the COM port
hub.
11 Once complete, click Save and Exit to save the information. Otherwise, click Exit to
exit without saving your changes.