User's Manual

The ILS Inventory Wand
Page 17 of 23
number and tapping the <Set> button. This allows for adjustment when items of different
thickness are being scanned.
Tap the Start button be begin the Shelf Order Search. You must begin reading items at the
starting shelf location in the list.
The Shelf Order Search screen displays the following information:
1. Items in file – the original count of the items read from the Shelf Order file.
2. Items Read – the number of items read during the search.
3. Items in order – the number of items that were read in shelf order.
4. Items not in order – the number of items that were read that are not in shelf order.
Figure 1-18: Shelf Order Search Screen
The Offset in use and the Alerts enabled settings may be changed at any time during the
search.
When you are finished searching tap the <Done> button at the bottom of the screen. If all of
the items shelf order list are found, an alert screen will notify you. Tap the Ok button to
continue.
1.7.3. Shelf Order Alert
When a Shelf Order Alert is displayed for an item that is not in the list, only the barcode will
be displayed. The Item Status field will indicate “Not in List”.
The <Show Prev.> button will display the previous item read. You can tap this button to
display the last item in order to assist in locating the item on the shelf. This item should
probably be removed from the shelf, since it is not in the shelf order list.
The <Show Next> button will display the next item read.
The <Show Item> button returns the display to the item that is not in the list.
Tap the Continue button when you are ready to resume the scan. Be sure to start at the
position you were in when the alert occurred.