Installation Instructions

INSTALLATION PROCEDURE,
TPRO7100 AND TPRO7200
____________________________________________________________________________________________________________________________
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY.
Dwg. No. 813910 Rev. *60 Page 6
•
Digital voltmeter "universal type DVM”
•
A BNC to SMB interface cable
•
Frequency counter capable of resolving 1 Hz at 13.56 MHz
4.3 TPRO7100 AND TPRO7200 CONNECTIONS
The TPROs are delivered with:
•
External 12V wall pack power supply
•
Optional Bar code scanner (TPRO7200 only)
The TPRO7200 has a connector panel on the side.
Install the peripherals as follows:
1. Power Connections
•
Connect the 12V wall pack power supply to the power jack.
2. Bar Code Scanner Connections (TPRO7200 only)
•
Connect the bar code scanner to the connector labeled “COM 4”.
•
Plug the bar code scanner power supply into an AC outlet (120V, 60Hz).
3. Network Connections (TPRO7200 only)
•
Connect the network cable to the RJ-45 connector on the connector panel.
5.0 TPRO7200 SINGLE BOARD COMPUTER
The SBC is the interface controller for the following tasks:
•
Communication of read only RFID tag data via 10Base-T ethernet or bar code data via
RS-232 to the application server.
The SBC interface connections are described in the table below.
SBC Interface Table
Cable SBC TR4090 Connector Panel
Function
Connector Panel
Label
Connector Type
COM1 J1 J6
COM2 J2 DIAGNOSTIC COM 2 9 pin M
MiniD-Sub
COM3 J3 PASS THRU COM 3 9 pin M
MiniD-Sub
COM4 J4 BARCODE COM 4 9 pin M
MiniD-Sub
Ethernet J13 ETHERNET ETHERNET RJ-45
Power J6 J2
Antenna J1
6.0 BASEBAND SIGNALS
It is possible to observe baseband signals and noise at two locations. The noise floor you will
observe is comparable to what can be seen in EAS systems.