Installation Instructions
INSTALLATION PROCEDURE,
TPRO7100 AND TPRO7200
____________________________________________________________________________________________________________________________
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY.
Dwg. No. 813910 Rev. *60 Page 9
8.3 BASEBAND MEASUREMENT AT TP1 OF TR4090 BOARD
9.0 OPTIONAL BARCODE SCANNER SETUP (TPRO7200 ONLY)
Bar Code Scanner: Metrologic MS951 Hand-Held laser Scanner
Interface: Serial (RS-232)
Refer to the
MS951 Programming Guide
.
1.
Scan in the bar code at the top of page 4 entitled “Enter/Exit Program Mode”.
2.
Scan in the bar code entitled “Short Range Activation Out of the Stand” on page 4.
3.
Scan in the bar code entitled “Transmit Start/Stop” on page 41.
4.
Scan in the bar code at the top of page 4 entitled “Enter/Exit Program Mode”.
10.0 JUMPER AND SWITCH SETTINGS FOR THE SBC (TPRO7200 ONLY)
10.1 JUMPER SETTINGS