Specifications

Compliance
WRTZ-2000 TX/RX meets regional UHF broadcast rules:
FCC: UHF, 902 – 928 MHz / 4 Watt EIRP (US only)
ETSI: UHF, 865 – 868 MHz / 2 Watt ERP at 865.7 – 867.5 MHz
accordant to ETSI EN 302 208 version 1.3.1 (2009-07) (EU only)
Singapore: UHF, 920 – 925 MHZ/3.28 Watt EIRP, Modulation ASK,
7.4 MHz – 8.8 MHz/7.4 dBuA/m, Modulation None
Evolve System - Peripheral Support
•
VisiPlus
• EVOLVE-Store (EV3 board)
Site Planning
Evaluate how antenna will be mounted: Concrete, Wood, or Tile finished
flooring. EAS and RFID power supplies should be planned based on the
configuration layout. If using peripherals such as VisiPlus or a DVR relay,
the trigger cable and 4C VisiPlus cables are routed from the SEC (if
necessary) to PRI (PSB) EAS reader.
Plan the distance to the door-frame, and whether or not specific antenna
types are required (see page 2 with options for some common layouts -
other "Mall opening" layouts are supported).
For the best alarm performance (reduced False Alarm counts), customer is
expected to maintain the Storefront layout so as to avoid high tag
concentrations directly in front of the system.
RFID Coax Cables and M-to-M Adapter connector for
some custom installations
Number 1 (shown at buttom left) shows the RFID Reader with 8 Coax ports.
It is possible for all of the system UHF Antennas to be used simultaneously, and
in this case, 8 total Coax Cables are connected to the reader. 4 cables will be
be routed to the “Active” pedestal’s 2 RFID Arrays (4 total patch antennas); and
at the opposite sides (on left and right of pedestal in center), the Arrays facing
this pedestal will be connected. This is shown in the figure below: where each of
2 readers is shown driving FULL left and right aisle. Specific settings have to be
applied to the RFID Reader to allow proper function
RX Map:
Left Aisle (1) Right Aisle (0)
RX Map Settings RX Map Settings
RxMap 11 12 RxMap 01 34
RxMap 12 43 RxMap 02 21
RxMap 13 33 RxMap 03 33
RxMap 14 44 RxMap 04 44
Checkpoint Systems, Inc.
101 Wolf Drive
Thorofare, NJ 08086
1-800-257-5540
This drawing and the
accompanying written materials
are the exclusive property of
Checkpoint. Possession of this
document or any written
materials does not convey any
right to reproduce, disclose its
contents, or to produce, use or
sell anything it may describe.
Reproduction, disclosure or
use without specific prior
written authorization of
Checkpoint is strictly forbidden.
Any deviation to these
specifications must be
approved by project
management. Contact your
local Checkpoint office.
Specifications for
EVOLVE Exclusive E10 2.0
Systems (all models)
Approved By:
Engineering Services
Revision: *
Content: Compliance