User's Manual

Quick Start Guide: E10 2.0 RF/RFID Pedestals
Page 9 of 9
RFID Commissioning / UHF Antenna Tuning
This procedure requires RFID-EAS tool (see Required tools). An overview is
provided below.
• Launch DMS.
• Tune system for RF-EAS (connect to Evolve Board).
• Confirm default profile for RFID Reader(s). Apply Region and if
applicable, set the Application Mode to “Dual Aisle.”
• Perform RX Map and EPC Positioning setup for Left and Right aisles.
• Proceed with DMS to confirm detection.