User's Manual

Checkpoint Systems, Inc. – Field Service Installation Document – CKP P/N #######
Page 2 of 9
Main System I/O and UHF Ports for TX/RX Antenna
Tx/Rx Utilization of UHF Ports
“Rule of 3” - the coax connectors used that will have cables routed to the same
pedestal will always be spaced 3 connectors apart (i.e. 4th connector away from
RX3 is used for RX4 in at the connector labeled 2 above)
For other aisle configurations, refer to Installation Manual or procedures below.
1 RFID Coax Connector Side (“top”)
2 “Side Panel” with 4-Pin Digital Input,
Serial Port via RJ-45 and LTS/SND
(covered in the GPIO section)
3 Ethernet Port - see Client Network
connection
4 IN - Interped communication
5 OUT - Interped communication
6 +12V DC Power Input conn.
Standard Single Aisle: UHF Ports
numbered to match RX Patch wiring
Patch inside
Active Ped.
Patch inside any
neighboring Ped.
1RX 2 -
2 - RX 4
3 - -
4 - -
5RX 1 -
6 - RX 3
7 - -
8 - -