User's Manual

CounterpointIntelligent

Deactivator‐RF(CPiD‐RF)

SYSTEMSETTINGS

AccesstoDIPSwitches&Reset

Switchesprovidecontrolofuniquesystemfeatures

andfinetuningofperformance.Pullaccesspanel

openfromright.Bymovingselectedswitchesupor

down,youcanadjustsystemmode,powerandgain.

OperationModes

OperationModeisaglobalsystemsettingwhich

configuresCPiD‐RFtodeactivate(only),deactivate

anddetect,orverifyactiveEAStags.

SetSwitches(SW)2and3toconfigureMode.

SetSW3,4and5toadjustthe system’s

ReceiverGain(or“Sensitivity”).Seenextpage.

OTHERUSERCONTROLS

ResetButtonforstartup

EachtimetheunitispoweredON,presstheresetbutton,waituntiltheVioletLEDlightison,

thenpressResetagain.Theunitmakesaclickingnoisewhileittunes;thisisnormal.IftheRed

orVioletLEDeverstayson,resettingmayenablepropersystemfunction(see

Troubleshooting).

ChangeModes

PressReset1time toapplyanewmode.Ifredorateallightstayson,pressResettwice.

AdjustingSensitivity

Usetable/descriptiononthefollowingpage.

StatusLEDDefinitions

DetailsonLEDDefinitionsandRxGain(seebelow)arefoundonalabelbelowthechassis“top

plate.”Releasefrontlatchfirst,andthenremovethelid(orchassisframe)toviewlabel.

VolumeKnob

Ifsoundisnotloudenough,adjustormovephysicallocation.Duringbusyperiods,turnitup!

ModeName

Known

Selection

SW2SW3

iDeact Mode5OFFOFF

iDetectHT Mode6ONON

iDetect/Deact Mode4OFFON

iVerify Verification ON OFF