User's Manual

OmniVerifier

OnthesideoftheOmniVerifierunitslidethetoggleswitchto“DV.”Depresstheredbutton.

Theamberandgreenlightswillilluminate.Ifthegreenlightisblinking,thisindicatesthatthe

batteryislowandtheunitneedstobeplacedontothechargingcradle.

HoldtheOmniVerifierdeviceapproximately24inchesabovethedeactivationpadandslowly

loweruntiltheredindicatorilluminatesandthesounderbeeps.Thisindicatesthatthe

deactivationfieldispresent.

IfyouexperiencedeactivationproblemswhentestingyourdeactivatorsusingeithertheDV1000

orOmnidevices,please checkthefollowingbeforeplacingaservicecall:

1. Locatethedeactivationelectronicsboxandconfirmit’s

pluggedinand/orthepowerswitchisturnedon.Agreenlight

shouldbeilluminatedonthefrontoftheelectronicsboxto

indicatepower.

2. Ifthelightison,thepowersupplyispluggedinandthereis

stillnodeactivationfieldpresent,confirmtheantennacable

andconnectorarepluggedintothebackoftheelectronic

housing.

3. Iftheproblemspersist,contactCheckpoint’sService

Department(800‐253‐7580)toplaceaservicecall.When

placingaservicecall,pleasegiveabriefdescriptionofthe

problemyouareexperiencing.

TestingProcedures