User's Manual

EVOLVE360RF–PulseListen
Problem Resolution
Theantennadoes
notalarmwhen
testedwith
labels/tags
Checktheredlightisilluminated(solidlight)onthebadgeboard(on
Sideonly)atthebaseofthepedestal.
Usingthekeyprovidedduringtheinstallation,followtheguidebelow
tocheckifthesystemisenabledordisabled.
(Pleasenote:theredlightonEVOLVEantennadoesnotflash
constantlywhenindisabledmode).
1. LocalDisable:
•Turnswitchclockwisefor1second,thenreturntocenter
position.LEDdisplay–slowblinking,1pulseevery3seconds.
Blinkinglasts20secondsandthengoessolid.
2. LocalEnable:
•Turnswitchclockwisefor4seconds,thenreturntocenter
position.LEDdisplay–fastblinking,10pulsesasecond.Blinking
lasts20secondsandthengoessolid.
3. Ifthelightison:
•Andconfirmedsystemsisenabled.Re‐testthesystem.
•Ifalltheabovechecksandtesthavebeencarriedoutandthere
isstillnodetection,thenpleasecallCheckpointSystemsservice
desk.
9
TroubleshootingGuide