Full Product Manual

5. Slide the tank ring bracket (K) onto the end of the

safety tank ring (J) as shown. Attach the tank ring

bracket to the rear panel (L) with 2 screws (BB)

as shown.

6. Attach the drip tray support (I) to the front beam

(U) and rear panel (L) with 4 screws (AA) as

shown.

Remove the cap and the nut from the igniter (M).

Secure the igniter to the right panel (N) with the

nut. Then, reassemble the cap to the igniter.

Hardware Used

1/4-20 x 5/8 in.

Screw

X 2

Hardware Used

3/16-24 x 1/2 in.

Screw

X 4

Nut Cap