User Manual

SGS-P-7.4-01-F02-CTS
This document is issued by the Company under its General Conditions of Service accessible at
http://www.sgs.com/terms_and_conditions.htm. Attention is drawn to the
limitation of liability, indemnification and jurisdiction issues defined therein.
Any holder of this document is advised that information contained hereon is solely limited to visual examination of the safely and readily accessible portions of the
consignment and reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is
to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. Any unauthorized
alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law.
[Rev.:01 Mar.10
th
2014] Page 2 of 16
Inspector: Zuoxin Zhou Factory Representative: Mr. Lv
1. Quantity:
Conform
Style / Item/
Article
P.O. No. Order Qty.
Inspection Qty.
(Presented Qty. for insp.)
Number of Cartons
Packed
Not Packed
Packed
Not packed
RJ21-IN / 2000 2000 0 500 0
Total: 2000 2000 0 500 0
2. Style & Color Conformity:
Subject to client's evaluation
Comments: - Please refer to photos.
3. Workmanship Appearance / Functional Inspection Findings:
Within AQL
Inspection Method Applied:
ANSI / ASQ Z1.4- 2008, Single sampling plans for normal inspection,
Level II Sample size: 125
Acceptable Quality Level (AQL) for: Critical: N/A Major: 1.5 Minor: 4.0
Defect description. Critical Major Minor
The anchor point was broken. 0 4 0
Scratch mark on black crystal plate. 0 0 2
Total defectives: 0 4 2
Maximum allowed: 0 5 10
4.
Product
-
Specific Data Measurement / Field Test on Reduced Sample Size:
Subject to client's evaluation
Check points Qty Test Result Specification/Tolerance
4.1 Packaging check 125 Pass SGS WI
4.2 General safety check 125 Pass
SGS WI
4.3 Hi-pot test
- Type of tester: WB2671A
- Cal. certificate available: Yes
- Due. date: 14-Jul-2016
- S/N: 0606127
125 Pass 1200Vac 10mA 2Sec
4.4 Product identification check 125 Pass SGS WI
4.5 Visual & normal functional check 125 Pass At 120V 60Hz
4.6 Manual shock check for foreign
material and loose assembly inside the
main set & accessory parts
125 Pass
SGS WI
4.7 Assembly fitting check 125 Pass
SGS WI
4.8 Power plug fitting check 125 Pass
SGS WI
4.9 Foot uneven check 125 Pass By glass piece
4.10 Power switch on/off 3 times 125 Pass SGS WI