User's Manual

User Manuals
B10: Battery cover
Initial operation
 Take out the receiver, open the bracket B9, pull down the battery cover B10, and install the battery correctly
according to the positive and negative signs. After the product is fully displayed, enter the pairing mode for 2
minutes, and you can see the receiving symbol flashing. Before the pairing is successful, all data are
displayed as short lines.
 Use a screwdriver to screw the lock screw of the battery cover on the back of the development launcher,
open the battery cover, install the battery correctly, and insert the probe wire to be used into socket A1, A2,
A27 or A28.
 When pairing mode, you can press
button of the transmitter to transmit the signal manually or wait for
the transmitter to transmit the signal automatically.
 After pairing, the receiver will display the temperature of each channel of the transmitter and the
corresponding alarm setting status.
 If necessary, type C data cable can be used to supply power to the transmitter. After connecting the external
power supply, the backlight will be on all the time, and the battery power supply will be cut off automatically
without removing the battery.
Switch the devices OFF and ON
 Press and hold the button
for 3 seconds, the device is switched OFF mode, in shutdown mode, press
the button once to turn the device back ON.
 The receiver will also enter a pairing mode of up to 2 minutes after turned ON with press button.
Transmitter
1
， Calibration function
 Compared with the standard thermometer, when the gap of the product is found，Press and hold the 【CAL】
key for 5 seconds to enter the calibration mode. First, the CH1 real-time temperature position is switched to
the flashing 0.0, and the “CAL” is flashing display at the same time. Press the 【+】 or 【-】key to adjust the
temperature value that needs to be offset. Step 0.1 each time, press and hold to adjust quickly; Press the
【CAL】key to confirm the calibration value of CH1 and go to the temperature calibration of CH2. CH2's
real-time temperature position is switched to flashing 0.0, and the “CAL” is flashing display at the same time.
Press the 【+】 or 【-】 key to adjust the temperature value that needs to be offset. Each time you press 0.1
step, press and hold to quickly adjust……
 If there is no effective operation within 20 seconds during the setting process, the modified value will be
saved and automatically returned to the standard mode.
2
， RF function ON/OFF
 Press and hold the key for 2 seconds to turn OFF the RF function, and the symbol in the display is
disappears.
 After the RF function is turned OFF, press the key
once to turn ON the RF function again, and the
symbol will be displayed again.
 When the RF function is ON, the symbol will flash once for each transmission.