User`s guide

XVII. Unified Wire Manager (UM)

T4 Boot Configuration (T4 CNAs)

This module can be used to view and configure T4 PXE and FCoE Option ROM settings for

Chelsio T4 cards.

PXE physical functions and order of ports for PXE boot can be selected here. The same module

can be used to configure FCoE Option ROM. Here port order for target discovery and discovery

timeout can be set. Under the Boot section, LUN can be configured as boot device from the

discovered FCoE targets.

Enable the Option ROM only if you are planning to boot the system via PXE or install the

operating system on FCoE LUN.

Figure 8.8.3 (d) - PXE Boot configuration for T4 CNAs