User`s guide

XVII. Unified Wire Manager (UM)
Chelsio T5/T4 Unified Wire For Linux Page 326
T4/T5 Boot Configuration
This module can be used to view and configure PXE, FCoE and iSCSI Option ROM settings for
Chelsio T4 and T5 adapters.
PXE physical functions and order of ports for PXE boot can be selected using the PXE option.
You can also enable/disable PXE BIOS and set VLAN.
The FCoE option can be used to configure FCoE Option ROM settings. Using the Function
parameter, you can set port order for target discovery and discovery timeout. The Boot
parameter can be used to discover targets and view properties of LUNs assigned to the targets.
Clicking on the Discover Targets button will list all the discovered targets and clicking on target
will list assigned LUNs on the right. Select a LUN from the list to view details. Show WWPN
parameter will display the WWPNs of all the ports.
There are four configurable parameters available under the iSCSI option: Function, Initiator,
Network and Boot Devices. Using the Function parameter you can enable/disable BIOS, set
port order for target discovery and discovery timeout. The Initiator parameter allows you to
configer initiator properties like IQN name, header digest and data digest. You can also set
CHAP authentication method or disable it. The Network parameter allows you to configure
various settings on the port like enabling/disabling IPv6 support, specifying initiator IP type, etc.
Using the Boot Devices option you can set various iSCSI target properties.
Enable Option ROM only if you are planning to boot the system via PXE or
install the operating system on discovered iSCSI or FCoE LUN.
Note