User`s guide

Chapter I. Chelsio Unified Wire
Chelsio T5/T4 Unified Wire For Linux Page 33
ii. Untar the tarball:
E.g. For RHEL 6.3, untar using the following command:
[root@host]# tar -zxvfm ChelsioUwire-x.x.x.x-RHEL6.3_x86_64.tar.gz
iii. Change your current working directory to Chelsio Unified Wire package directory and run
the following command:
[root@host]# ./install.py
iv. Press “Enter” to read EULA or “q” to quit.
v. Press "y" to accept the EULA and continue or "q" to quit.
vi. Select the required T5/T4 configuration tuning option as described below. Enter the
corresponding number in the Input field and press Enter.
vii. Next press 1 if you want to install OFED along with the configuration tuning option selected
in step (vi) or 2 to skip OFED installation. Press Enter to continue with your choice.
viii. Select the Installation type as described below. Enter the corresponding number in the Input
field and press Enter.
1. Install all Chelsio drivers: Install all the drivers provided in the Unified Wire
package.
2. Install NIC and TOE drivers: Install only the Network and TOE drivers.
3. Install bypass drivers and tools: Install only the bypass drivers and tools.
4. Install WD drivers and library: Install only Wire Direct drivers and libraries.
5. EXIT: Exit the installer.
ix. The selected components will now be installed.
x. Reboot your machine for changes to take effect.
If the installation aborts with the message "Resolve the errors/dependencies
manually and restart the installation", please go through the install.log to resolve
errors/dependencies and then start the installation again.
Note
The Installation options may vary depending on the Configuration tuning
option selected.
Note
High capacity RDMA and High capacity TOE options are currently not
supported with T5 Adapters.
Note