User`s guide

Chapter XVIII. Unified Boot
Chelsio T5/T4 Unified Wire For Linux Page 351
ix. Choose the boot port to try the PXE boot. It is recommended to only enable functions and
ports which are going to be used. Please note that enabling NIC Func 00 will enable port 0
for PXE, enabling NIC Func 01 will enable port 1 and so on for NIC function. Please refer
the table below:
NIC Function enabled
Ports enabled
NIC Func00
00
NIC Func01
01
NIC Func02
02
NIC Func03
03
x. Hit [Esc] and then [Y] to save configuration changes.
xi. Reboot the system.
xii. Hit [F2] or [DEL] or any other key as mentioned during system startup to enter the system
setup.
VLAN id currently not supported in Legacy and UEFI environments.
Note