CLS 3869--100 CLS--3869 VERSA VERSA--Roll™ Digital Roller Drum 3800 North Mill Road • Vineland, NJ 08360 • USA Tel: 1-800-843-1794 • Fax: 1-800-922-4361 Web: www.cglifesciences.
FEATURES 1. 2. 3. 4. 5. 6. 7. 8. Trouble free brushless DC motor Integrated power supply for 100 to 240VAC service. Illuminated LED display. Non-slip trouble free toothed belt design for long life. 1 - 30 revolutions per minute. Rotary speed knob has locking ring. Uses 12 inch diameter Drums. Available in: (106 Position 13-18mm Tubes, 60 Position 20-25mm Tubes, 50 Position 30mm Tubes) Adjustable front tilt angle.
SET-UP 1. Connect the detachable power cord to the AC/DC converter (DC power supply) and connect to “INPUT 24Vdc” receptacle in rear of unit and then plug power cord into a suitable electrical outlet. (See Figure 1) 24Vdc INPUT Receptacle Mains Fuse 2A/250V Figure 1 - Rear of Unit 2. Place an accessory drum on the roller shaft.
Close-up Alignment notch Alignment Notch located in back of drum Figure 3 - Accessory Drum -Figure 4 - Rear of Drum Place the drum over the Roller shaft - push and turn to lock into position (See figures 3 & 4). To remove, grasp handle and gently pull drum away from drive pin. Continue to pull until drum is completely removed from shaft.
OPERATION See figure 6 To operate, turn the main power switch to the “ON” position. Turn the speed control knob to set the desired rpm value. The units are designed to operate within a range of 1 - 30 revolutions per minute. Adjust the speed by turning the speed control knob, CW to increase speed, CCW to decrease it. The unit will ramp up (or down) to your selected speed. Turn the “LOCK” ring clockwise about an eighth of a turn to prevent any inadvertent changes to the set speed.
Warranty Chemglass, Inc. guarantees this unit against defects in material and workmanship for a period of two years from the date of purchase. If the unit should malfunction, it must be returned for evaluation. If the unit is determined to have a defect in materials or workmanship, then it will be repaired or replaced at no charge. Tampering with the unit or damage resulting from excessive current, heat, moisture, vibration, corrosive materials, or misuse will void this warranty.
