M-1 Tech Paper

079213-2
1.04 DELIVERY, STORAGE, AND HANDLING
A. All materials must be delivered in original, unopened containers with the manufacturer's
name, labels, product identification, and batch numbers. Damaged material must be
removed from the site immediately.
B. Store all materials off the ground and protect from rain or excessive heat until ready for
use.
1.05 JOB CONDITIONS
A. Environmental Conditions: Do not apply material if precipitation or if such conditions appear
to be imminent. Minimum application temperature 32° F (0° C) and rising.
B. Protection: Precautions should be taken to avoid damage to any surface near the work zone
due to mixing and handling of the specified coating.
C. Do not apply to joints that have frost present.
1.06 SUBMITTALS
A. Submit two copies of manufacturer's literature, to include: Product Data Sheets.
B. Material Safety Data Sheets (MSDS).
C. Samples:
1. Color Selection: For each color choice, manufacturer's sample bead
consisting of strips of actual products showing all colors available.
2. Verification: 2 sets of each type and color of joint sealant required. Install
joint sealant Samples in 1/2 inch wide joints formed between two 6 inch
long strips of material matching appearance of exposed surfaces adjacent
to joint sealants.
3. Submit laboratory tests or data validating product compliance with
performance criteria specified.
4. Contractor to submit list of references from 5 projects similar in scope to
this Project. Include contact name and phone number of person charged
with oversight of each project.
1.07 DELIVERY, STORAGE, AND HANDLING
A. Comply with Section 016000.
B. Deliver products in original factory packaging bearing identification of product,
manufacturer, and batch number. Provide Material Safety Data Sheets for each product.
C. Store products in a location protected from environmental damage including but not limited
to, physical damage, construction activity, precipitation, and direct sunlight.
D. It may be helpful to condition products to approximately 60° F (16° C) to 70° F (21° C) for
use.
E. Take appropriate precautions and care as stated on Material Safety Data Sheet.