Datasheet

TDS # CW2200
PRODUCT DESCRIPTION
CircuitWorks

Conductive Pen makes
instant highly conductive silver traces on
circuit boards. CW2200 is used in
prototype, rework, and repair of circuit
boards by linking components, repairing
defective traces, and making smooth
jumpers. The silver traces dry in minutes
and have excellent adhesion to most
electronic materials. Engineers, repair
technicians, and manufacturers will find that
the CircuitWorks

Conductive Pen speeds
project completion and cuts rework time.
 Single component system
 High electrical conductivity
 Fast drying
 Highly adherent to circuit boards
 Operating temperature to 400F (205C)
TYPICAL APPLICATIONS
CircuitWorks

Conductive Pen may be used
for electronics applications including:
 Circuit Trace Repair
 Solderless Linking of Components
 EMI Shielding
 Solderable Terminations
 Quick Prototype Modifications
CHEMTRONICS

Technical Data Sheet
CircuitWorks

Conductive Pen
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Composition
Material Silver Filled Polymer
Silver Particle Size 10-15 microns
Color Silver Gray
Setting Rate <2mm/hr.
Properties
Conductivity 0.02-0.05 ohms/sq/mil
0.00005-0.000125 ohm cm
Max. Temperature 400F (205C)
Tack-Free Time @ 25C 3 to 5 Minutes
Cure Time @ 25C 20 to 30 Minutes
Solder Wetting 2 to 3 Seconds
Electrical Conductivity Excellent
Adhesion Excellent
Flexibility Good
Chemical Resistance Good
Tip Diameters
MTP 0.8 mm (0.03 inches)
STP 1.2 mm (0.05 inches)
Shelflife 12 months
COMPATIBILITY
CircuitWorks

Conductive Pen material has
excellent compatibility with materials used
in printed circuit board fabrication. As with
any chemical system, compatibility with the
substrate must be determined on a non-
critical area prior to use.