User's Manual

IMPORTANT:
Be sure to first follow the
Quick Start Guide
on the reverse side
of this guide
to complete initial setup
of your H550.
Features and
Functions Guide
H550
Bluetooth®
Handsfree Headset
TURNING HEADSET
ON AND OFF
To turn your headset on, slide the switch
toward the microphone. The indicator light
flashes blue (if paired with another device),
or is steadily blue (if ready to be paired).
To turn your headset off, slide the switch
toward the charging plug. The indicator light
will turn off.
EARHOOKS AND YOUR
HEADSET
Your H550 headset is supplied with three earhooks.
The earhook is attached onto a hinge pin, and is
placed onto your ear when using your headset. To
install an earhook on your headset:
040059o
2 Pull Earhook Up
Hinge Pin
1 Open Earhook
CHANGING VOLUME
BUTTON ORIENTATION
You can also change the orientation of the
volume buttons on your headset.
Turn the headset power off.
Press the Volume button you want to
assign as the "volume up" button and
slide the switch toward the microphone.
The indicator light is either steadily lit or
flashing in blue.
1
2
• The essential requirements and
other relevant provisions of Directive
1999/5/EC.
• All other relevant EU Directives.
European Union Directives
Conformance Statement
0168
Product
Approval
Number
The above gives an example of a typical Product
Approval Number.
You can view your product’s Declaration of Conformity
(DoC) to Directive 1999/5/EC (to R&TTE Directive) at
www.motorola.com/rtte. To find your DoC, enter the
product Approval Number from your product’s label in
the “Search” bar on the web site.
Hereby, Motorola declares that this
product is in compliance with:
MAKING CALLS
Note: Your H550 supports both Handsfree and Headset
Profiles. Accessing call functions depends upon which
profile your phone supports. See your phone's user's guide
for more information.
Function Action
Make a voice dial call Tap the Call button
and speak the
name after the tone
End a call Tap the Call button
Receive a call Tap the Call button
Reject a call Tap a Volume button
Redial last call Press and hold the
Call button until you
hear a beep
Answer a second Tap the Call button
incoming call
Reject a second Tap a Volume button
incoming call
MAKING CALLS CONTINUED
Function Action
End an active call and Tap a Volume button
resume a call on hold
Mute or unmute a call Tap both Volume
buttons
Disable the First slide the switch
indicator light toward charging plug
(to turn headset off),
then press and hold
both Volume
buttons AND slide
the switch towards
the microphone (to
turn headset on)
Note: Some features are phone/network dependent.
INDICATOR LIGHTS
With the Charger Plugged In
Headset Indicator Headset Status
Steady blue Charging
Off Charging complete
With No Charger Plugged In
Headset Indicator Headset Status
Off Power off
Steady blue Pairing mode
10 rapid blue/purple Pairing successful
flashes
Slow blue pulse Connected
(on a call)
Slow blue flash Standby
(not on call)
Blue flash Idle (not connected)
Quick blue flash Incoming/outgoing call
Slow purple pulse Connected
(on a muted call)
Note: After 5 minutes of inactivity, the light stops flashing to
conserve power, but the headset remains in standby mode.
AUDIO TONES
Audio Tone Headset Status
Single high tone when Volume at minimum
pressing volume button or maximum
Two tones Low battery
repeated every 30 sec.
No audio indications; Out of range
deteriorating quality
Ring tone Incoming call
Single high tone Pairing confirmation
Low to high tone Voice activation
Single high tone End call
Low to high tone Phone network
not available
Two ascending tones Mute enabled
Two descending tones Mute disabled
Slide Switch
Indicator Light
Slide
Switch
Volume
Buttons
Open the attached
earhook 90 degrees from
the headset.
Gently lift and pull the
top of the earhook up
and off the upper hinge
pin. Then, pull it away to
remove it.
Position the headset for
right or left ear use (right
ear use is displayed).
Hook the bottom of the
earhook onto the lower
hinge pin, then lift and pull
the top of the earhook
over the upper hinge pin.
1
2
3
4
WEARING THE
HEADSET
Once you have attached your desired
earhook, follow these steps to wear your
headset on your ear:
1
2
3
Open the attached
earhook 45 degrees from
the headset.
Loop the earhook over
your ear.
Press earhook to your ear.
When worn, your headset
will look like this on your
head:
1
2
3