User's Manual

ManualsBrandsCheng Uei Precision Industry ManualsElectronicsCDMA2000 1x RTT & CDMA2000 1x EV-DO Rev.A

Document Title

MV82P1 USER GUIDE

Version

V.1

Date

2010/6/2

FOXLINK is a registered trademark of FOXLINK Incorporated.

No part of this publication may be reproduced or distributed in any form or by any means, or stored in a

database or retrieval system, without the prior written permission of the publisher.

FOXLINK Incorporated reserves the right to make changes in technical and product specifications without

provisional notification.

Summary of content (9 pages)

PAGE 1
Document Title MV82P1 USER GUIDE Version Date V.1 2010/6/2 Copyright FOXLINK is a registered trademark of FOXLINK Incorporated. Copyright © 2010 FOXLINK Incorporated. All rights reserved. No part of this publication may be reproduced or distributed in any form or by any means, or stored in a database or retrieval system, without the prior written permission of the publisher. FOXLINK Incorporated reserves the right to make changes in technical and product specifications without provisional notification.
PAGE 2
1 .MV82P1 introduction 1.
PAGE 3
1.
PAGE 4
1.
PAGE 5
Gateway：
PAGE 6
1.
PAGE 7
2.Operational description 2.1 Tune up procedure 1. Use calibrating config. file first. 2. Power on. 3. Run calibration procedure. 4. Run test procedure. 2.2. MV82P1 features 2.2.1 General specification An EVDO module i.e. MV82P is a mobile broadband modem that delivers built-in high-speed cellular connectivity to Notebook/Netbook/MID, offering 3G mobile Internet access on CDMA2000® EV-DO networks in US markets. And this module with a size of 26.8x30x4.5 mm.
PAGE 8
2.2.2 Hardware Specification The hardware block diagram for MV82P1 is shown as below: The PCB for MV82P1 is 8 layers.
PAGE 9
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter As long as these conditions above are met, further transmitter test will not be required.