User's Manual
Table Of Contents
- General
- Module introduction
- Hardware description
- Approvals
- CE Approvals(ETSI)
- FCC Approvals
- ATEX Approvals
- Module Pinout
- Hardware Description
- Hardware Diagram
- Interface characteristics
- Absolute Maximum Ratings
- Environmental characteristics
- Recommended operating conditions
- DC Electrical Characteristics
- Digital IO Specifications
- AC Electrical Characteristics
- Physical Dimensions and Footprint
- Physical Dimensions
- Recommended Footprint
- Soldering Temperature Time Profile (for reflow so
- Recommended temperature time profile for lead-fre
- Reliability Test
- Application Precautions
- Safety precautions
- Engineering design and using precautions
- Storage conditions
- Packaging
- Carrier tape
- Reel
- Ordering Information
- Drawing of Product Label
- Disclaimer
- RoHS Declaration
- Data Sheet Status
- Reference Documents
- Contact Information
SZU06C1 Product Manual
SZU06C1 PM(Rev 2.0)
14
8 AC Electrical Characteristics
DD OP
V =3.3V,T =25 ,SZU06A1 connected a SMA aten na with 50Ω load℃ .
No
Parameter
Test conditions
Min
Typ.
Max
Unit
1
Frequency range
2400
2500
MHz
2
Channel number
See Table 10.2 for the
correspondence
between channel and
frequency
CH11
CH26
3
Input impedance
47
50
53
Ω
4
Receiver sensitivity
PER=1%
-102
-101
-99
dBm
5
Input level Input voltage
PER=1%
10
dB
6
High-side adjacent channel
rejection, 1% PER. Desired
is reference signal at 3dB
above reference sensitivity
level
Interferer is reference
signal at +1
channel-spacing.
-
33.75
-
dB
Interferer is filtered
reference signal
at +1
channel-spacing.
-
52.5
-
dB
7
Low-side adjacent channel
rejection, 1% PER. Desired
is reference signal at 3dB
above reference sensitivity
level
Interferer is reference
signal at -1
channel-spacing.
-
35
-
dB
Interferer is filtered
reference signal
at -1
channel-spacing.
-
54.7
-
dB
8
Alternate channel rejection,
1% PER. Desired is
reference signal at 3dB
above reference sensitivity
level
Interferer is reference
signal at ±2
channel-spacing.
-
45.9
-
dB
Interferer is filtered
reference signal
at ±2
channel-spacing.
-
56.8
-
dB
9
Co-channel interferer
rejection, 1% PER
Desired signal 10 dB
above sensitivity
limit
-
-2.6
-
dB
10
RSSI Resolution
-
0.25
-
dB