MWA6S WiFi Module Spec Manual MWA6S WiFi Module Spec Manual Version: 1.
MWA6S WiFi Module Spec Manual 1. MWA6S Module Introduction MWA6S is a 2.4G Wi‐Fi module using MT7686DN chipset, which integrates a 1T1R 802.11 Wi‐Fi radio, a 192MHz ARM® Cortex®‐M4 CPU, some special ports and multiple slow IOs. A PCB printed antenna is used in MWA6S, which max gain is 1.5dBi. 2.
MWA6S WiFi Module Spec Manual 3. Size and Package Space requires 3.
MWA6S WiFi Module Spec Manual [Recommended backplane pad package]
MWA6S WiFi Module Spec Manual 4. Electrical parameters Absolute electrical parameters Para Description MIN MAX Unit VCC Power Supply -0.3 3.63 V VIO IO Input -0.3 5.5 V 0 85 ℃ Tstg Storage Temp Normal working conditions Para Description MIN VCC Power Supply 2.97 VIO IO Input VIL Typical MAX Unit 3.3 3.63 V -0.3 — 3.63 V IO Low Level Input -0.3 — VCC*0.25 V VIH IO High Level Input VCC*0.75 — VCC V VOL IO Low Level Input 0 — VCC*0.
MWA6S WiFi Module Spec Manual 5. RF index Basic Parameter Operation Frequency: 802.11b/g/n(HT20):2412-2462MHz;n40(HT40): 2422‐2452MHz WiFi Standard IEEE 802.11b/g/n20/n40 Transmission rate 11b:1,2,5.5 and 11Mbps 11g:6,9,12,18,24,36,48 and 54 Mbps 11n:HT20 MCS0~MCS7,HT40 MCS0~MCS7 Channel 802.11b/g/n(HT20):CH1~CH11; HT40: CH3~CH9 Antenna Type: PCB printed antenna TX Indicator Parameter 11b 1Mbps 11g 6Mbps 11n HT20 MCS0 11n HT40 MCS0 MIN Typical Value MAX Unit Transmission Power — 20.
6.
7. OEM/Integrators Installation Manual List of applicable FCC rules This module has been tested and found to comply with part 15.247 requirements for Modular Approval. Summarize the specific operational use conditions This module can be applied in household electrical appliances as well as TV and IP camera. The input voltage to the module should be nominally 2.97-3.63 VDC ,typical value 3.3VDC and the ambient temperature of the module should not exceed 85℃.
Information on test modes and additional testing requirements a) The modular transmitter has been fully tested by the module grantee on the required number of channels, modulation types, and modes, it should not be necessary for the host installer to re-test all the available transmitter modes or settings.
FCC statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.