User Manual

7. OEM/Integrators Installation Manual
List of applicable FCC rules
This module has been tested and found to comply with part 15.247 requirements for Modular
Approval.
Summarize the specific operational use conditions
This module can be applied in household electrical appliances as well as TV and IP camera. The
input voltage to the module should be nominally 2.97‐3.63 VDC ,typical value 3.3VDC and the
ambient temperature of the module should not exceed 85℃.
Limited module procedures
N/A
Trace antenna designs
N/A
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the
radiator& your body. If the device built into a host as a portable usage, the additional RF exposure
evaluation may be required as specified by§2.1093.
Antennas
The module has one PCB antenna and the antenna gain is 1.5dBi.
Label and compliance information
When the module is installed in the host device, the FCC ID label must be visible through a window on
the final device or it must be visible when an access panel, door or cover is easily re‐moved. If not, a
second label must be placed on the outside of the final device that contains the following text:
“Contains Transmitter Module FCC ID:2AMUU‐MWA02” or “Contains FCC ID:2AMUU‐MWA02”.
The FCC ID can be used only when all FCC ID compliance requirements are met.