User Manual

4. After activate the motors, push up the Left Stick slowly to fly up the drone, and

pull down the Left Stick slowly to the lowest end(Picture 8), then the drone will

land on the ground slowly.

5. It’s recommended to repeat above Step 4 to practice.

6. Adjust relative transmitter Trimmer button to adjust the rudder if the drone tilts

to one side when flying.

Checklist before Flight

3. Activate(unlock) motors: Move the Left Stick

and Right Stick at the same time (45 degree

inward) to start the motors and repeat

previous step again to lock the motors.

(Picture 12)

1. The camera is in front of the drone. Keep the drone front away from you.

2. Power on the drone and check the direction of the rotating propellers. The left

front and right rear A propellers rotating

clockwise while the right front and left rear

B propellers rotating counterclockwise.

Picture 12

www.udirc.com

Calibration Instruction

Please follow below steps to calibrate the drone if the drone becomes imbalance

after crashing during the flight, and can not be adjusted by trimmer button and

cause difficult operation.

1. Power off the drone, then turn off the transmitter switch.

2. Turn on the transmitter switch, push the Left Stick all the way down to the

lowest position (Picture 13) and then release. The Left Stick will back to the

middle position automatically (Picture 14). The transmitter is ready for

frequency pairing mode.

3. Power on the drone and put it on a flat surface in a horizontal position. The

drone body lights change from flashing to solid bright, which indicates

successful frequency pairing.

4. Do not move the Left Stick before successful

calibration. Push the Right Stick as Picture 15

and then release. The drone body lights flash,

which indicates that the drone is calibrating.

When the drone body lights remain solid,

which indicates successful calibration.

Notice: When the drone is fiercely impacted or crashed, it may cause the gyro can not

recover and cause difficult to control, if so, then you need to power off and power on

again to calibrate.

Picture 13 Picture 14

Picture 15