Datasheet

0.125 REF
(3.18)
2.58 (65.5)
.40 (10.2)
GS100701
GS100502
GS100501
0.125 REF
(3.18)
15/32 - 32 TPI
Leads
Optional
2.58 (65.5)
.40 (10.2)
4
1
PIN 2
Not Used
3
Magnet
1
3
4
VCC
(brown)
Pull-up
Resistor
Output
(black)
Ground
(blue)
GS1005–GS1007 Series
GEARTOOTH SPEED SENSOR
Dimensions inches (mm)
All tolerances ±0.005 (0.13) unless otherwise noted.
Hall-effect geartooth speed sensor with adjustable aluminum housing.
Features
 Senses motion of ferrous geartooth targets
 Near zero speed sensing capability
 Immune to rotational alignment
 10 bit dynamic threshold detection offers
- Automatically adjusting magnetic range
- Self compensating to target geometry
- Immune to target run out
 Compatible with unregulated power supply
 Reverse battery protected to -24VDC
 Discrete wire version: 20 AWG, tin plated, polyolefi n insulation
 Hard coat anodized aluminum housing
Applications
 Exercise equipment
 Food processing equipment
 Speedometer
Notes: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. See page 27 of our sensor brochure for recommendations.
Pull-up resistor should be connected between output (Black) and Vcc (Brown).
Specifi cations
Part Number
Operating
Voltage Range
(VDC)
Supply
Current
(mA max.)
Output
Output
Saturation
Voltage
(mV max.)
Output
Current
(mA max.)
Operating
Temp Range
(°C)
Storage
Temp Range
(°C)
Thread Barrel Length Leads
Connector
GS100501
5,0 – 24 6 sink 400 20 – 40 to 125 – 40 to 125 M12-1 65 mm
12 mm
circular
GS100502
5,0 – 24 6 sink 400 20 – 40 to 125 – 40 to 125 M12-1 65 mm 20 AWG
x 1 m BBB
GS100701
5,0 – 24 6 sink 400 20 – 40 to 125 – 40 to 125 15/32" –
32
1.00" 20 AWG
x 1 m BBB
Open Collector
Sinking Block
Diagram
Specifi cations subject to change without notice.