Datasheet

Magnet
1
3
4
VCC
(brown)
Pull-up
Resistor
Output
(black)
Ground
(blue)
15/32 - 32 TPI
MP100701
1.00
(25.4)
0.125 REF
(3.18)
2.58 (65.5)
.40 (10.2)
MP100502
Specifi cations subject to change without notice.
MP1005–1007 Series
Solid state, magnetic position sensors in adjustable, threaded housing.
Features
 Excellent output stability over operating temperature range
 Regulated power supply not required
 Reverse battery protection to -24 V DC
 Wire: 20 AWG, tin plated, polyolefi n insulation
 Anodized aluminum housing
 South pole activated
 RoHS Compliant
 Open Collector (NPN) output can be used with bipolar or cmos logic
circuits with suitable pull up resistor
- Output switches low (off) when the magnetic fi eld at the sensor
exceeds the operate point threshold
- Output switches high (on) when the magnetic fi eld is reduced to
below the release point threshold
MAGNETIC SENSOR
Applications
 Limit switch
 Home security
 Door position
Notes: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. See page 27 of our sensor brochure for recommendations.
Pull-up resistor should be connected between output (Black) and Vcc (Brown).
Specifi cations
Part
Number
Operating
Voltage Range
(VDC)
Supply
Current
(mA max.)
Output
Output
Saturation Voltage
(mV max.)
Output
Current
(mA max.)
Operating
Temp Range
(°C)
Storage
Temp Range
(°C)
Operate
Point
Gauss
(max.)
Release
Point
Gauss
(min.)
Housing
Color Wires
MP100502
3,8 – 24 7,5 3-wire sink 400 25 – 40 to 125 – 40 to 125 245 60 Red 20 AWG
x 1 m BBB
MP100701
3,8 – 24 7,5 3-wire sink 400 25 – 40
to 15 0 – 4 0 to 150 245 60 Black 20 AWG
x 1 m BBB
Dimensions inches (mm)
All tolerances ±0.005 (0.13) unless otherwise noted.
Open Collector
Sinking Block
Diagram