Datasheet

0.750
(19.05)
0.139
(3.53)
0.975
(24.77)
0.475
(12.07)
0.500
(12.70)
0.135
(3.43)
0.425
(10.80)
0.124
(3.15)
0.37 REF.
(9.4)
0.080
(2.03)
5.9
(150.0)
0.050 Typ.
(1.27)
0.250
(6.35)
ø 0.129
(3.28)
Wire Insulation: Polyolefin
23
1
2
3
1
Permanent
Magnet
1
3
2
VCC
(red)
Pull-up
Resistor
Output
(green)
Ground
(black)
Ferrous
Vane
Regulator
VN1015 Series
Magnetically activated digital vane sensor in a rugged, overmolded plastic housing with three pins or 3-wire fl ying leads.
DIGITAL VANE SENSOR
Specifi cations
Part Number
Operating
Voltage Range
(VDC)
Supply
Current
(mA max.)
Output
Output
Saturation Voltage
(mV max.)
Output
Current
(mA max.)
Operating
Temp Range
(°C)
Storage
Temp Range
(°C)
Termination
VN101501
3.8 – 24 7.5 3-pin sink 400 25 – 40 to 85 – 40 to 85 pins
VN101503
3.8 – 24 7.5 3-wire sink 400 25 – 40 to 85 – 40 to 85 24 AWG
x 150 mm l eads
Features
 Immune to moisture and dust
 Reliable and repeatable
 No mechanical contacts to wear out
 Operates from 4.5 to 24 V DC
 Reverse battery protection to -24 V DC
 RoHS Compliant
 Open collector (sinking or NPN) output can be used with bipolar or
cmos logic circuits with suitable pull up resistor
 Sensor body material: glass-fi lled polyester
 Recommended vane parameters: low carbon material at least 0.040"
thick, should penetrate to a depth < 0.120" from bottom of sensor slot.
Notes: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. See page 27 for recommendations.
Pull-up resistor should be connected between output (Green) and Vcc (Red).
Dimensions inches (mm)
All tolerances ±0.005 (0.13) unless otherwise noted.
Open Collector
Sinking Block Diagram
Specifi cations subject to change without notice.
14