Quick Start Guide

and another PC/laptop. Switch off this PC/laptop

or deactivate the connection on this PC/laptop.

5 Follow the instructions in the software.

If the red LED of the mouse flashes quickly, the

connection has failed.

• Try to establish the connection again.

3 Connecting the mouse via the

receiver

The receiver is in a compartment on the bottom of

the mouse and is held in place by magnets.

1 Pull the receiver out of the housing.

2 Connect the receiver to the USB socket on the

PC/laptop.

3 Set the switch on the bottom of the mouse to

"RF".

4 Adjusting the sensitivity of the

mouse (DPI number)

• Press the DPI button on the top of the mouse.

The LED flashes depending on the setting:

1x = 600 dpi

2x = 1000 dpi

3x = 1600 dpi

4x = 3200 dpi

5 Charging the mouse

When the red LED flashes, you should charge the

mouse soon.

• Connect the charging cable to the mouse and a

USB socket on the PC/laptop.

6Disposal

This device contains a lithium ion battery.

This cannot be replaced.

Do not dispose of the device in the house-

hold waste. Batteries may contain pollut-

ants which can harm the environment and health.

Dispose of the battery with the device in a retail out-

let or at your local recycling depot. Returning the

device is compulsory and free of charge.

Battery charge status

The battery in the mouse is already

charged. You can use the mouse

immediately.

• Before first use, however, we recommend that

you charge the mouse fully with the cable

supplied.

64410045-01_DE-EN-FR-ES-IT-NL-SV-NO-DK-FI-PL-CS-SK_KA-MW8Ergo.fm Seite 10 Donnerstag, 18.