Operator's Manual

Page 13
To recall the stored stations
- Press the
button to enter “Preset
Recall”
- Press the
or button or rotate the
knob to nd the desired programmed
radio station, e.g., “P10”
- Press the
button to conrm. “P10”
station will be played.
To store and recall stations in quick-access
presets (FIG. 12).
Additionally, the unit features ve quick-
access preset buttons (1 – 5) that allow user
to quickly store and recall 5 stations in FM
and 5 in AM wavebands.
NOTE: The memory presets P01, P02, P03,
P04, and P05 are the same whether they
were programmed using preset store or
quick-access preset buttons.
To store the current radio station, press and
hold the desired quick-access preset button
(1-5) until the preset number is shown on the
display. The station is then stored under the
selected quick-access preset button.
Repeat this procedure for the remaining
quick-access presets. Stations stored in
the preset memory can be overwritten by
following the procedures described above.
To recall stations from the preset memories,
briey press the desired quick-access
preset button while the unit is in radio mode.
The preset number and station frequency
will appear on the display.
FIG. 12
SYSTEM MENU SETTING
In any operating mode, press the MODE
button and hold down for 2 seconds to en-
ter System Menu. While in System Menu you
can reset the unit to factory settings (Fac-
tory Reset). Or look up rmware version (SW
Version).
Briey press the MODE button to exit Sys-
tem Menu and return to the last active op-
erating mode.
FACTORY RESET (FIG. 13)
If your radio fails to operate or some infor-
mation on the display is missing or incom-
plete, carry out the following procedure:
- Press and hold the MODE button down
for 2 seconds to enter System Menu.
“System” will appear on the display.
- Press the
button to see “Factory
Reset” on the display.
- Press the
button to see “No” and “Yes”
on the display.
- Press the
or button or rotate knob
until the display shows bracket around
<Yes>, then press the button to
conrm the setting. After selecting Factory
Reset/Yes, your radio will reset and switch
off automatically.
FIG. 13