Operator's Manual

Page 8
OPERATION
ATTACHING BATTERY PACK
(FIG.1)
2
3
4
5
PRESET
MODE
BASS
FIG. 1
Detach
CAUTION:
Always switch off the
unit before removing the battery pack.
Align the raised rib on the battery pack
with the grooves in the unit, and then slide
the battery pack onto the unit.
NOTICE: When placing the battery pack
onto the unit, be sure that the raised rib
on the battery pack aligns with the groove
inside the unit and that the latches snap
into place properly. Improper attachment
of the battery pack can cause damage to
internal components.
DETACHING BATTERY PACK
(FIG. 1)
Depress the battery-release button to
release the battery pack. Pull the battery
pack out and remove it from the unit.
INSTALLING COIN CELL
BATTERY (FIG. 2)
WARNING:
Danger of explosion
if battery is incorrectly replaced. When
replacing battery, replace it with the
same or equivalent type CR2032. Observe
correct polarity (+ and –) when replacing
batteries. Do not store or carry batteries in
such a way that metal objects can contact
exposed battery terminals.
Your unit is equipped with memory function
in order to store the time and your preset
radio stations. When the unit is in the OFF
position, this memory function is powered
by one coin cell battery that is included
with the unit.
1. Loosen the two screws on the battery
door counterclockwise with a Philips
screwdriver (not included) to remove the
screws and the battery door.
2. Install the coin cell battery observing
the correct polarity.
3. Replace the battery door, insert the
screws and tighten it clockwise.
DANGER:
Do not ingest battery.
Chemical burn hazard. This product
contains a coin cell battery. If the coin
cell battery is swallowed, it can cause
severe internal burns in just 2 hours and
can lead to death. Keep new and used
batteries away from children. If you think
batteries might have been swallowed or
placed inside any part of the body, seek
immediate medical attention.
＋
3V x 1
CR2032
FIG. 2
Attach
Battery-Release Button
Coin Cell Battery
Battery
Door
Screws