Manual

Engine Maintenance And Servicing Manual
——Remove the thin plastic protective tape
5. Removal and installation of oil filter and oil pressure sensor.
Removal：
——Remove the oil filter. Rotate oil filter counterclockwise
during removal.
——Remove the oil pressure sensor
Installation：
——Apply engine oil on the sealing gasket of oil filter and
screw into the connector. Tightening torque is 12－17Nm.
Or screw into oil filter by hand. once rubber sealing gasket
contacts cylinder block, tighten another 3/4－1 turns.
——Apply Lotite 243 sealant and screw it to the main oil
passage of cylinder block. Tightening torque is 20 ft-lbs.－
The threaded hole of oil pressure sensor is 1/4″－
18NPTF.
The operating voltage of oil pressure sensor is 6－24V.
The starting warning pressure is 30±15kPa.
Fig. 91
Tightening torque 18.0-25.0Nm
O
il filter
O
il pressure
sensor
Fig. 92