Engine

Put the cylinder gasket into the dowel.
Note: The side with indicator of the cylinder
gasket shall be upward.
Install the cylinder head in place with the key slot
of the cam shaft downward vertically.
Note: The cylinder gasket can only be used for
one time, so the removed one shall be
replaced with a new one when removing
the cylinder head.
Put the bolts and the flat gasket of the cylinder
head into the threaded hole to screw them in by
hands.
Tighten the bolts of the cylinder head in four steps
according to the order illustrated in the figure:
a. First step: tighten it at the moment of
20-40N.
b. Second step: tighten it at the moment of
20-40N.
c. Third step: rotate 90 degrees.
d. Fourth step: rotate 90 degrees.
e. Moment-angular tension indicating
wrench can be used for degree rotation.
A. Location Pin B. Gasket
A-20
PDF created with pdfFactory Pro trial version www.pdffactory.com