Engine

Hold the middle of the right belt that is away
from both the crankshaft gear and camshaft gear
with the thumb and the first finger. If the tension
of the belt is up to standard, the belt shall be
able to twist at 90°at this point.
To adjust the tension of the belt, loosen the two
fixing bolts of the tension pulley, push the
tension pulley to the right with a screwdriver as
a ram, then fasten the fixing bolts again, rotate
the crank shaft and check the tension again.
Right tension may be obtained after 2~3
adjustments. Fasten the tension pulley with
fixing bolts for a moment of 16-20N. after such
adjustments are completed.
Key
Bush
Bolt: M12*1.5*30
Tightening torque: 52~60Nm
Key
Bolt: M
8
*
25
Tightening torque: 16~20Nm
Tension Pulley
Crankshaft Gear
Timing gear
A-6
PDF created with pdfFactory Pro trial version www.pdffactory.com