LUBRICATION SYSTEM

OIL FILLING
——To fill the engine with 3.1 ± 0.15L of oil
(SAE10W/30SF grade, or SAE5W/30SJ grade at
temperature lower than -18℃)
——The oil surface shall be between “max” and
“min” on the dipstick.
OIL STRAINER ASSEMBLY
Disassembly:
——To unscrew the locknut of the oil strainer support
and take out the nut and gasket.
——To unscrew and take out the support bolt.
——To unscrew oil strainer flange bolts (two) and
take out two gasket bolts with spring.
——To install the new oil strainer gasket to the oil
pump flange, setup the oil strainer assembly and
screw up two bolts with gaskets. —To screw the
oil strainer support to the cylinder using M8
bolts, put the support onto the stud on the left of
the second main bearing cap, place back the flat
washer and screw up the nuts manually.
——To screw up the oil strainer flange bolt to
8-12N.m.
——To screw up the support bolt to 17-23N.m.
——To screw up the locknut to 17-23N.m
M6X16: M6x16 Bolt
Fastening Torque Of
8.0-12.0N.M
Oil Strainer Assembly
Nut
Flat
Fastening Torque Of 8.0-12.0N.M
Washer Bolts with Spring (Two)
B-5
PDF created with pdfFactory Pro trial version www.pdffactory.com