Service Manual

53
6. Installation and Adjustment of
Headlamp
6.1. headlamp Installation Step
The installing steps of headlamp are
reverse to those for removal.
6.2. Introduction to headlamp function
6.2.1. Front view
See right figure:
1 Low beam light
2 Position light
3 High beam
4 Turn light
6.2.2. Back view
See right figure:
1 Low beam light
holder
2 Headlamp’s plug
3 High beam light
holder
4 High beam up/down
adjusting nut
5 High beam left/right adjusting nut
6 Low beam up/down adjusting nut
7 Low beam left/right adjusting nut
6.3. Adjustment of headlamp light
Headlamp uses half closed light combination type. So it is easy to be maintained; it is halogen
light with less mechanism and high luminous intensity, which will prolong bulb life.
The correctness of headlamp adjustment will influence the driving safety. So it needs special
device to adjust the beam. Pay attention to law regulations and verify the following items before
adjustment:
a. Tire pressure should be conformity with standard;
b. Car is unload (except for spare tire and equipped tools, and include driver weigh for
sedan);
c. Park the car on horizontal road or workplace;
d. The lens surface of headlamp should be clean;
e. Check the power supplies if is working correctly, and the bulb installed correctly.
1
2
3
4
2
7
6
1
3
5
4