Service Manual

73
3. Installation of Evaporator Assy
The installing steps are reverse to those for
removal.
4. Disassembly/Reassembly of
Evaporator Interior
Preparation of tool(s): cross screwdriver, socket
wrench
4.1. Removal Step
4.1.1. Refer to the Removal of Evaporator Assy,
and take off the evaporator assy.
4.1.2. Remove the harness and connector from
the evaporator.
4.1.3. Remove three screws from the
intermediate part of the evaporator, and
partition the evaporator into two parts.
4.1.4. Remove the air direction regulating
mechanism from the distributor with a cross
screwdriver (as shown in the figure).
Torque: 1.5±0.5 Nm