Workshop Manual

4.10 If the rear brake is found too tight during driving,

adjust the length of push rod: Turn it in the cloclwise

direction to eliminate the friction.

4.11 Remove three bolts as shown in the picture wit a 10#

box wrench.

1.12 Take off the brake wheel cylinder, and detach and

check whether it is in good condition.

4.13 If it is necessary to check the brake drum

bearing, remove the lock nuts as shown in the

picture with a 32# sleeve and a torque spanner,

and take off the brake drum bearing.

Torque: 250±10 N.m

5. Installation Step

Refer to Removal Step.

Bolts

Lock Nuts