Workshop Manual

without the alarm horn).
4.6. Disalarm mode
a) How to disalarm:
After the body enters into the alarm mode: ① press down any pushbutton on the remote
controller.
b) Body state after disalarming:
1. If the triggered alarm door is in open state (not give an alarm for the vehicle without
the alarm horn).
Press down the UNLOCK pushbutton on the remote controller to ① disalarm; ② unlock
the central door lock.
Press down the LOCK pushbutton on the remote controller to ① disalarm; ②enable the
arming to be failed.
2. If the triggered alarm door is in close state (not give an alarm for the vehicle without
the alarm horn):
Press down the LOCK pushbutton on the remote controller to ① disalarm; ② disarm, and
carry out the secondary arming after 28 s.
Press down the LOCK pushbutton on the remote controller to ① disalarm; ② enter into
the arming mode.
4.7. Arming failure mode
a) If door, engine hood, trunk fail to close at the same time, pressing the Arm key can’t set
up the arming condition:
After the failure of body arming: ① the left/right turn signal lamp lights.
III. Fog and Position Lamps Control