Workshop Manual

9
Screws for idle gear shaft
Bolts-for gearshift housing and Backup lamp switch assembly
Transmission housing (5)
Figure 2
3. Separation of gear shift mechanism and transmission
Remove the gearshift mechanism assembly from the place as shown in Figure 3; as a result of sealant,
the disassembly process may be difficult, so, use such tools as a hand hammer etc. to knock on the bulge at
flank of housing of the gearshift mechanism, and then take out the whole gearshift mechanism assembly
until the two housings completely separate; remember to be slow when taking out the gearshift mechanism
assembly, so as to prevent the return spring as shown in the figure from dropping out inside the transmission;
during disassembly, be careful not to damage the junction planes of the two housings, so as to avoid oil leak
after re-assembly.
Gearshift mechanism assembly
Locating seat of fork shaft
for all gears (3)
Assembly of locating
seat of fork shaft
Return spring (remember to prevent
it from dropping out)