Workshop Manual

10
Figure 3
4. Disassembly of the connecting bolts for clutch and transmission housings
Use a tool to remove the connecting bolts for transmission and clutch housings as shown in Figure 4.
Remember to remove the bolts both inside and outside the clutch housing when disassembling, and a sleeve
with long connecting rod is required when removing the bolts inside the clutch.
Connecting bolts for transmission and clutch housings
Figure 4
5. Separation of transmission and clutch housings
After the bolts for transmission and clutch housings are removed, separate clutch housing and
transmission housing (Figure 5). as a result of sealant, the separation process may be difficult, so, use such
tools as a hand hammer etc. to knock on the bulge at flank of housing of the transmission, and then take out
the whole transmission housing until the two housings completely separate; during disassembly, be careful
not to damage the junction planes of the two housings, so as to avoid oil leak of the transmission after
re-assembly.