Workshop Manual

13
Figure 8
9. Disassembly of gearshift mechanism
As shown in Figure 9, remove the gearshift arm bracket bolts and reverse gear lockup mechanism bolts
first, use a hammer and a special tool to knock off all spring pins, use a special tool to remove the split
washer, and then disassemble each part of the gearshift mechanism.
Gearshift arm bracket bolts (2 in total)
Reverse gear lockup mechanism bolts (2 in total)
Split washer
Figure 9
10. Disassembly of input shaft
As shown in Figure 10, Use a special tool (such as bearing remover etc.) to remove the two bearings on
the input shaft first, use a special tool to remove the rear snap ring, and then take off the fifth gear
synchronizer assembly.