Workshop Manual

15
11. Disassembly of output shaft
The method and process for disassembly of output shaft are basically the same as those for input
shaft and the output shaft can be disassembled to the status as shown in Figure 12.
Figure 12
12. Disassembly of differential
As shown in Figure 13, use a special tool to take off the two bearings first, remove the bolts for driven
gear and differential housing, remove the driven gear, knock off the fixing pin of the planetary gear, and then
take out every part inside the differential (Figure 14).
Fixing pin of planetary gear Bolts for driven gear and differential housing (8 in total)
Figure 13