Workshop Manual
29
Install the assembled idler assembly (assembly of idler assembly is comparatively simple, please refer
to its disassembly process) onto clutch housing, and then install reverse gear fork mechanism assembly with
tightening torque of the two reverse gear rocker arm bracket bolts as 25±2Nm. Clean the junction part of
clutch and transmission housings and apply sealant (oil resistance silicone sealant, HZ1213Q/320222
YAP02-92) on it, and then install the magnet. See Figure 30.
Reverse gear fork mechanism assembly Idler assembly
Magnet
Figure 30
Apply sealant on junction part
of clutch and transmission
housings
倒档摆臂支架
螺栓(拧紧力
矩 25±2Nm)