Workshop Manual

6. Inspection of thermostat:
(1) Under normal temperature, inspect seating status of
the valve and it should tightly seat.
(2) Inspect opening temperature and maximum stroke of
the valve.
Opening temperature of the valve is 87±2℃
Maximum stroke of the valve is 8mm
Full opening temperature of the valve is 104℃
(3) Then check if the valve closes at the temperature
5 lower than the opening t℃ emperature. If not
compliant, replacement with a new thermostat is
required. Follow the order adverse to that for
disassembly of the thermostat to install it. When
installing, check if the gasket of the thermostat is
damaged, if thermostat seat and thermostat cover
casing plane are satisfactory. Check the sealing
gasket for damage, if damaged, replace with new
sealing element.
7. Disassembly of A/C pipeline
See Disassembly of A/C Compressor for disassembly
of A/C pipeline.
8. Disassembly of power-assisted steering pipeline.
See Disassembly of Power-assisted Steering Oil Pump
for disassembly of power-assisted steering pipeline.
9. Disassembly of intake and exhaust manifold.
9.1 Use a 10# sleeve to remove the fixing bolt of air
intake pipe.
9.2 Use a cross-head screwdriver to loosen the clamp
connecting intake hose and electronic throttle body.