Workshop Manual
10.2 Use pliers to remove the fixing clip of gearshift
control cable outer case and then take off the gearshift
control cable.
10.3 Use a 13# sleeve to loosen the adjusting screw of
clutch control cable and then take off the clutch control
cable.
10.4 Use a 13# sleeve to loosen the fixing bolt of clutch
control cable on the transmission case.
10.5 Use a 17# wrench to loosen the bleeding bolt of
transmission case to discharge the gear oil.
10.6 See Service Manual for Chassis for disassembly
of suspension travel portion.
10.7 Use a crow to pry out the half shaft.
11. Disassembly of suspension portion
11.1 Use a 13# sleeve to remove the fixing bolt for rear
engine mount bracket of transmission case.
Torque: 60±5Nm.