Workshop Manual

Service Manual for Chery V525 Car Chassis
4.5 Remove two clamp screws of steering wheel plate
guard via cross screwdriver.
Torque: 1.5±0.5N.m
4. 6Remove four fixing bolts of screw cable via cross
screwdriver. Then remove screw cable.
Torque: 1.5±0.5N.m
4.7 It should be noted that when fitting the screw cable,
turn the inner disk to one direction until unable to be
turned further, and then turn about 3.2 circles at a reverse
direction, after aligning the mark, and confirm the steering
wheel is in horizontal position, and then carry out
assembly.
4.8 Remove the clip of combination switch via flat-tip
screwdriver, then pull out ignition switch and the plug
of combination switch.
4.9 Remove the fixing handle of engine hood via 8#
sleeve.
PDF created with pdfFactory Pro trial version www.pdffactory.com